SMT stapler splice tool
              Our company mainly serves SMT and electronics manufacturing plants worldwide for many years. we have two kinds of stapler type SMT splicer, one is used for edge splice copper clip (ST381D), another is used for splice no side clip (ST381F), their function is same, these two kinds of splicer and anti-static (ST381I,ST381K) and non-anti-static. It is also possible to install the SMT splice cart (ST381E). here is the ESD stapler splice tool, the part number is ST381I.


 
             The SMT splice tool and positioning scissors are an indispensable tool in the connection of SMT chip components. The auxiliary clamping copper is pressed into the SMT carrier belt to achieve seamless connection through the positioning scissors, and will not damage the components. Made of high quality raw materials.
 
Usage: 1, press hard to open the two handles of the pliers, so that the lower pressure plate and the bottom plate open, take a piece of copper clips placed on the two bolts of the copper clips, pay attention to the correct position of the copper buckle, 2, the two disconnected material belt respectively take a end, respectively move the two card material bars parallel to the bottom plate, and then the disconnected material belt is aligned above the copper buckle, and then card the material belt. 3, hold the two handles with your hand, and use even force to close the two handles until the lower pressure plate and the bottom plate are combined into a level, so that the copper buckle will jam the material belt. 4, finally let the two handles open, unscrew the card bar, take out the connected material belt.
Features:
1, the principle of stapler, convenient and fast;
2, can be quickly installed on the receiving table, saving time;
3, paper tape, material tape all compatible, good expansibility;
4, the copper plate is easy to install, greatly improve efficiency;
5. Fast and accurate feeding;
6,Use for our SMT stapler splice clip(SC281C,SC281D)
 
Product advantage: SMT single side bonding belt and bonding copper buckle together, solid and reliable bonding. It is used to improve work efficiency by 35%, save materials by 40%, fully utilize the remaining materials, reduce the number of downtime, and extend the service life of the machine. Long service life, experimental data show that it can knead more than 500,000 times (equivalent to 500,000 materials)